DOL 26 stern sensor CA-P-18-NF-CA-SCR-B-2T, 105107

What is the capacitive sensor DOL 26 CA-P-Ø18-NF-CA-SCR-B-2T?

The capacitive sensor DOL 26 CA-P-Ø18-NF-CA-SCR-B-2T is a specialized version for threadless mounting, providing the user with full control over the detection process. Designed with a smooth Ø18 mm housing, this sensor is intended for systems where sensors are fixed using clips or sealing glands, rather than nuts.

Unlike "fixed" factory versions, this model comes equipped with two trimmers (2T). This allows the sensor to adapt to challenging conditions (e.g., strong vibration or dusty feed) while maintaining the benefits of a smooth housing that is easy to clean and adjust in height.

Benefits of the Threadless Adjustable Model

• Ideal for Clip Mounting. The smooth body slides easily into plastic feeder holders (like Roxell or similar), where a threaded sensor might damage the mount.
• Precise Adaptation (2T). Thanks to Time Delay and Sensitivity adjustment, you can use this sensor even where standard factory settings fail (e.g., on very light feed).
• Quick Level Adjustment. To change the line stop point, simply loosen the clamp and slide the sensor up or down. It takes seconds.
• Hygiene. The absence of threads means no place for pathogens to accumulate. This is critical for poultry houses with high biosecurity standards.

Applications of DOL 26 CA-P-Ø18-NF-CA-SCR-B-2T

This sensor is the choice for retrofitting specific lines:

• Lines with Frequent Reconfiguration. Where the "cap" height in the control pan needs regular changing.
• Intensive Sanitation Zones. The smooth surface does not trap dirt during high-pressure washing.
• Handling Non-Standard Mixes. Where individual sensitivity tuning is needed, but the mounting spot is designed for a smooth 18 mm sensor.

Why choose the smooth 2T sensor

This combines the ergonomics of a smooth body with the "brains" of a fully functional sensor. You don't have to compromise between mounting convenience and performance quality.

Installation of DOL 26 CA-P-Ø18-NF-CA-SCR-B-2T

1. Fixing: Insert the sensor into the mount. Secure its position with an external element (clamp/clip). Ensure the active part is submerged in the hopper.
2. Connection: 2-wire scheme. The sensor connects in series with the load. Works like an automatic switch.
3. Calibration: Remove the protective cap. Adjust the "Delay" and "Sens" trimmers with a small screwdriver to achieve the desired operation mode.

Comparison with M18 Model (Threaded)

The key mounting difference:

This is the best choice for systems with threadless sensor mounting.